Volkswagen Golf Owners Manual: Vehicle lifting points
Fig. 205 Lifting point at front for the lifting platform or vehicle jack
Fig. 206 Lifting points at rear for the lifting platform or vehicle jack
First read and observe the introductory information
and safety warnings The vehicle may only be lifted at the points shown in the illustrations and . If the vehicle is not raised on the lifting points shown, the vehicle could be damaged . There is also a risk of serious injury .
Lifting platforms with fluid filled cushions (receiving platforms) may not be used for lifting the vehicle.
There are many precautions that have to be followed when lifting a vehicle on a workshop hoist or floor jack. Do not try to lift a vehicle on a lifting platform or vehicle jack unless you have the training, knowledge and experience to be able to do so safely.
Using the jack to lift the vehicle .
WARNING
- Always read and heed the operating instructions from the lifting platform or vehicle jack manufacturer and any legal regulations before lifting the vehicle.
- All occupants should leave the vehicle before it is lifted.
- The vehicle should only be lifted at the points indicated in the illustrations and . If the vehicle is not lifted at the points shown, it could fall off the lifting platform when work is carried out, e.g. when the engine or gearbox is removed.
- The vehicle jacking points must be placed on the centre of the vehicle lift support surfaces, with as much surface contact between the vehicle and the support surfaces as possible.
- Never start the engine when the vehicle is raised. The vibration of the engine could cause the vehicle to fall off the lifting point.
- If work has to be carried out underneath the lifted vehicle, secure the vehicle with suitable jack stands with a sufficient load-bearing capacity.
- Never climb up the lifting platform.
- Always ensure that the vehicle is not heavier than the lifting capacity of the lifting platform.
NOTICE
- Never lift the vehicle by the engine oil sump, the gearbox or the front or rear axle.
- To prevent damage to the underside of the vehicle when lifting, rubber pads must be used. Ensure that the lifting platform arms are able to move freely.
- The lifting platform arms must not be allowed to come into contact with the sills or any other part of the vehicle.
Using a mobile telephone in the vehicle without a connection to the external
aerial
First read and observe the introductory information
and safety warnings Both during telephone calls and in standby mode, mobile
telephones transmit and receive radio waves, which may also be ter ...
Rodent proofing
First read and observe the introductory information
and safety warnings Rodent proofing equipment is made up of special brushes
and casings and impedes entry to the engine compartment by rodents ...
Other materials:
Removing and installing rear 3-point seat belt, estate, with belt tensioner
Removing
WARNING
Observe safety instructions for pyrotechnic
components
→ Chapter.
Observe disposal regulations for p ...
Corrosion protection measures for wing surface in contact with wheel housing
liner
Note
The corrosion protection measure is to be carried out in the groove
of the wing of all new replacement parts which have not had the
additional sealant applied at the factory.
The additional sealant is intended to prevent the wheel hous ...
Basics for working on refrigerant circuit
Observe instructions specific to the workplace;
→ Volkswagen ServiceNet; Handbooks; Service handbook;
Environmental protection. Refrigerant from air
conditioning systems / refrigerant oils - to be displayed at
refrigerant designated working are ...
