VW Golf manuals

Volkswagen Golf Service & Repair Manual: Structure of factory finish, surfacer

Surfacer, 2-door vehicles

Structure of factory finish, surfacer

 -  Surfacer
Only the coloured areas of the body are filled.

 
     
Surfacer, 4-door vehicles

Structure of factory finish, surfacer

 -  Surfacer
Only the coloured areas of the body are filled.
Paintwork structure of factory finish, cathodic dip primer
Cathodic dip primer, 2-door version  -  Electrophoretic finish         Cathodic dip primer, 4-door ...

Structure of factory finish, base coat
Base coat, 2-door  -  Base coat Only the coloured areas of the body receive a base coat.         ...

Other materials:

Removing and installing Hall sender 3 -G300-
Removing     –  Release hose clips -1- and -2-, and remove air pipe.   –  Disconnect electrical connector -1-. ...

Introduction
This chapter contains information on the following subjects:  → Drink holders in the front centre console    → Drink holders in the rear centre armrest    → Drink holder in the rear side trim   Bottle holder Bottle holders are located in the open stowage areas of t ...

Renewing rear bonded rubber bush
Special tools and workshop equipment required Tensioning strap -T10038- Assembly tool -T10263- Assembly tool -T10356- Engine and gearbox jack -V.A.G 1383 A- Hydraulic press -VAS 6178- and thrust piece - ...

© 2016-2026 Copyright www.vwgolf.org