Volkswagen Golf Service & Repair Manual: Routing and securing wiring

Volkswagen Golf Service & Repair Manual / Electrical system / Technical data / Repair instructions / Routing and securing wiring

Mark lines prior to removal to prevent them from being interchanged and to ensure that they are fitted in their original positions. This applies for fuel, hydraulic and vacuum lines as well as lines for activated charcoal filter system and electrical wiring. Where necessary, make sketches or take photographs.

Due to the limited space in the engine compartment, it is important to ensure that there is adequate clearance to any moving or hot components to avoid damage to lines and wiring.

Contact corrosion

Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface ...

Battery

Battery - general notes Note All instructions and notes regarding this chapter are available under → Electrical Syste ...

Other materials:

Removing and installing drive shaft, left drive shaft, constant velocity joints VL100 and VL107, except for e-Golf
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Press tool -T10520- ...

Introduction
This chapter contains information on the following subjects: → Handling wheels and tyres → Rims → New wheels and tyres → Tyre pressure → Tread depth and wear indicators → Tyre damage → Spare wheel or temporary s ...

Repairs and faults in the airbag system
First read and observe the introductory information and safety warnings Repairs and modifications must always be carried out according to Volkswagen specifications . Modifications and repairs to the front bumper, the doors, the front seats, the headliner, or the bodywork should be carri ...