VW Golf manuals

Volkswagen Golf Owners Manual: Seat heating

Fig. 53 In the centre console: buttons for the front seat heating

First read and observe the introductory information and safety warnings

The seat cushions and backrests can be heated electrically when the ignition is switched on. Some seat versions have heated backrests.

Do not switch on the seat heating if one of the following conditions applies:

Function Using the seat heating  
Switching on Press the or button. The seat heating is switched on at the highest setting. All indicator lamps light up.
Adjusting the heating output Press the   or    button repeatedly until the desired heating level is set.
Switching off. Press the    or    button repeatedly until the indicator lamps in the button go out.

WARNING

Anyone experiencing reduced sensitivity to pain or temperature due to medication, paralysis or chronic illness (e.g. diabetes) could sustain burns on the back, buttocks and legs when using the seat heating. These burns may take a long time to heal or may never heal fully. Please consult a doctor to determine your own level of health.

WARNING

Wet upholstery can cause a fault in the seat heating and increase the risk of burns.

NOTICE

The seat heating should be switched off as soon as it is no longer needed. Otherwise fuel will be wasted.

Introduction
This chapter contains information on the following subjects:  → Seat heating    → Back massage function    → Folding the front passenger seat backrest forwards   Addit ...

Back massage function
Fig. 54 In the lower area of the driver seat: button for back massage function First read and observe the introductory information and safety warnings When the back massage function is switche ...

Other materials:

Deactivating APP function of wiper motor
The windscreen wiper system is equipped with an APP function (alternating park position). With the APP function, the wiper is moved up slightly once it has reached the lowest position. This occurs every second time the wiper system is sw ...

Assembly overview - sill panel moulding
  Note The illustration shows the sill panel moulding on the left side. The right-hand side is similar (mirror image of left-hand side). I: sill panel moulding, 4-door model II: sill panel moulding, 2-door model 1 -  Sill ...

Connecting brake pedal to brake servo
–  Hold ball head of push rod in front of mounting and push brake pedal in direction of brake servo, so that the ball head clicks into place. –  Check engagement by pulling briefly on brake pedal. ...

© 2016-2026 Copyright www.vwgolf.org