Removing and installing rotary light switch -EX1-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar.
Removing
–
Turn light switch to “0” position.
...
Repairs to CAN bus wiring
An unshielded two-wire line -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
is used for CAN bus wiring.
The colour codes of the CAN bus wiring can be gleaned from
the following table:
  ...
Renewing right oil seal
Renewing right oil seal, gearboxes with
flange shaft
Special tools and workshop equipment
required
Thrust piece -3305-
...