Volkswagen Golf Service & Repair Manual: Safety precautions when working on ignition system
| Risk of injury due to electric shock |
| The ignition system is under high-voltage when the engine is
running. Touching the ignition system may result in an electric shock. |
| – |
Do not touch or disconnect ignition cables when the engine is
running or being turned at starter speed. |
| Risk of damage to components |
| If the engine is washed while running and if electric cables are
connected or disconnected, components may become damaged. |
| – |
Switch off the ignition before connecting or disconnecting electric
cables. |
| – |
Also, switch off the ignition before washing the engine. |
Risk of scalding due to hot coolant
The cooling system is under pressure when the engine is hot. Hot
steam/hot coolant can escape - risk of scalding.
–
...
Other materials:
Assembly overview - fuel delivery unit/fuel gauge sender, vehicles with
four-wheel drive
1 -
Fuel pump control unit -J538-
Check with → Vehicle
diagnostic tester
Removing and installing
→ Chapter
2 -
Electrical connector
For fuel pump control unit -J538- ...
Adjusting bonnet
Adjusting bonnet
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Note
Vehicle must be standing on its wheels to enable bonnet to ...
Repairing run-flat tyres, PAX
General information
It is not always necessary to renew a tyre after it has lost
pressure and then been run in an uninflated condition.
Note
The affected tyre should be removed and checked for damage
by qu ...
© 2016-2026 Copyright www.vwgolf.org
Safety precautions when working on cooling system