First read and observe the introductory information
and safety warnings
Depending on the vehicle equipment level, the vehicle may have a SAFELOCK mechanism and anti-theft alarm .
| Function | Action |
|---|---|
| Locking the vehicle and activating the SAFELOCK mechanism. | Press the
button on the vehicle key once . |
| Locking the vehicle without activating the SAFELOCK mechanism. | Press the
button on the vehicle key twice . |
| Press the sensor on the outside of the door handle for locking the Keyless Access locking and starting system twice . | |
Press the central locking button
in the driver door once . |
The SAFELOCK mechanism deactivates the door opening levers if the vehicle has been locked. This makes it more difficult to break into the vehicle. The doors can no longer be opened from the inside .
When the ignition is switched off, the instrument cluster display may inform you about the activated SAFELOCK mechanism (SAFELOCK).
Deactivating the SAFELOCK mechanism
The SAFELOCK mechanism can be deactivated in one of the following ways:
button on the vehicle
key twice. The following applies when the SAFELOCK mechanism is deactivated:
Indicator lamp in the driver door
| After locking the vehicle: | Meaning |
|---|---|
| A red LED flashes for approximately 2 seconds, firstly at short intervals and then more slowly. | The SAFELOCK mechanism is activated. |
| A red LED flashes for approximately 2 seconds and then goes out. The light starts to flash again after approximately 30 seconds. | The SAFELOCK mechanism is deactivated. |
| A red LED lights up steadily for approximately 30 seconds. | Fault in the locking system. Go to a qualified workshop. |

WARNING
Locking and unlocking the vehicle with Keyless Access
Anti-theft alarmInformation on steering
First read and observe the introductory information
and safety warnings The steering should be locked every time you leave the
vehicle to make it more difficult for the vehicle to be stolen.
Electronic steering column lock
Vehicles with Keyless Access: the steering column will be locked if ...
Corrosion protection measures for wing surface in contact with wheel housing
liner
Note
The corrosion protection measure is to be carried out in the groove
of the wing of all new replacement parts which have not had the
additional sealant applied at the factory.
The additional sealant is intended to prevent the wheel hous ...
Mechanical controls on the front seat
Fig. 43 Front left-hand seat controls
First read and observe the introductory information
and safety warnings The layout of the controls on the front right-hand seat
is a mirror image of the layout of the controls on the front left-hand seat.
The following section contains a description o ...