Volkswagen Golf Service & Repair Manual: Removing and installing upper rear lid trim

Special tools and workshop equipment required

Wedges -T10383

Removing

Removing and installing upper rear lid trim

–	Detach retaining straps for rear shelf on left and right from window frame.

–	Release centre window frame -2- from mountings in rear lid and side trim panels -3- using wedge -T10383-.

–	Remove centre window frame -2-.

–	Release side window frame -3- from catches in rear lid and lower rear lid trim -1- using wedge -T10383-.

–	Remove side window frame -3-.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.
Remove any retaining clips left in mountings in rear lid using removal tool -T40280- and fit them in window frames for installation.

Installation is carried out in reverse order.

Special tools and workshop equipment required Removing – Fold down rear ...

Special tools and workshop equipment required – Remove upper rear lid trim → C ...

Securing engine on engine and gearbox support
Special tools and workshop equipment required Engine and gearbox support -VAS 6095- Workshop hoist -VAS 6100- ...

Removing and installing selector lever position display -Y26-
Removing Note The selector lever position display -Y26--1- is integrated in the selector lever gaiter and cannot be removed individually. The removal and ...

Removing and installing air duct for centre dash panel vent
Removing – Remove dash panel → General body repairs, interior; Rep. gr.70. – Remove air duct for centre dash panel vent -1- upwards from ...