Volkswagen Golf Service & Repair Manual: Removing and installing turn signal bulb

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Tail lights / Removing and installing turn signal bulb

Note

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Remove tail light cluster on body → Chapter.

–	Press retaining tabs -2, 3 and 4- in direction of arrow -A-.

–	Remove cover -1- from tail light.

Caution

The bulb holder must not be turned!

Otherwise the bulb holder will be damaged.

Pull the bulb holder in a straight line towards rear. If necessary, carefully release retaining lugs using a suitable screwdriver.

–	Pull bulb holder -5- in a straight line -arrow B- out of housing.

–	Pull rear turn signal bulb out of bulb holder.

Installing

Install in the reverse order of removal, observing the following:

Caution

Risk of damage to the bulb.

Do not touch the glass part of the bulb with bare fingers. Fingers leave traces of grease on the glass bulb, which vaporise when the bulb is switched on and cause the glass bulb to cloud over.

Wear, for example, clean fabric gloves when inserting bulbs.

–	Test functionality.

Removing and installing turn signal bulb

Removing and installing reversing light bulb

Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. ...

High-level brake light

...

Other materials:

Safety precautions when working on vehicles with a Start/Stop system
During work on vehicles with Start/Stop system, observe the following: WARNING Injury hazard as a result of automatic engine start in vehicles with Start/Stop system ...

Industrial dirt remover
Designation: Industrial dirt remover -ABS 600 000 10- Issued 05.2004 Product description The industrial dirt remover -ABS 600 000 10- is used for the removal of surface rust ...

Removing and installing ESP sensor unit -G419-
The lateral acceleration sender -G200-, the yaw rate sender -G202- and the longitudinal acceleration sender -G251- are installed together with the control unit for electromechanical parking brake -J540- in the ABS control unit -J104-. Th ...