VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf and Golf GTE

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Aux. heater/heater booster / Other control components / Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf and Golf GTE

  Note
If the remote control receiver for auxiliary coolant heater -R149- is renewed, the remote control receiver for auxiliary coolant heater -R149- needs to be adapted to the auxiliary and supplementary heater using the vehicle diagnostic tester in “Guided fault finding” mode.
Removing
–  Remove right C-pillar trim → General body repairs, interior; Rep. gr.70.
   
–  Disengage remote control receiver for auxiliary coolant heater -R149--1- using suitable tool at points marked with -arrows-.
–  Pull remote control receiver for auxiliary coolant heater -R149--1- off bracket in -direction of arrow-.
–  Separate connectors -2- and -3-.
Installing
Install in reverse order.
  Note
If the remote control receiver for auxiliary coolant heater -R149- is renewed, the remote control receiver for auxiliary coolant heater -R149- needs to be adapted to the auxiliary and supplementary heater using the vehicle diagnostic tester in “Guided fault finding” mode.
Specified torque
Trims, interior; Assembly overview - C-pillar trim → General body repairs, interior; Rep. gr.70.
 

Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf and Golf GTE

Removing and installing ambient temperature sensor -G17
  Note The ambient temperature sensor -G17- is used for determining the outside temperature and as a switch-on condition of the auxiliary and supplementa ...

Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf Variant
  Note If the remote control receiver for auxiliary coolant heater -R149- is renewed, the remote control receiver for auxiliary coolant heater -R149- nee ...

Other materials:

Assembly overview - door handle and door lock
  Note Only the left side is shown. The right side is similar. 1 -  Door lock Removing and installing → Chapter 2 -  Bolt 3 Nm For lock cylinder 3 -  Mounting bracket ...

Removing and installing trim for backrest release mechanism
Removing –  Pull operating lever -1- upwards -arrow A-. –  Insert flat-bladed screwdriver between trim and operating lever as shown in illustration. –  Releas ...

Removing and installing cruise control system switch -E45
  Note t  The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column combination switch -E595-. ...

© 2016-2025 Copyright www.vwgolf.org