Volkswagen Golf Service & Repair Manual: Removing and installing ambient temperature sensor -G17

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Aux. heater/heater booster / Other control components / Removing and installing ambient temperature sensor -G17

Note

The ambient temperature sensor -G17- is used for determining the outside temperature and as a switch-on condition of the auxiliary and supplementary heater via CAN bus.

–	Removing and installing ambient temperature sensor -G17- → Heating, air conditioning; Rep. gr.87.

–	Check ambient temperature sensor -G17-; vehicle diagnostic tester in “Guided fault finding” mode.

Other control components

...

Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf and Golf GTE

Note If the remote control receiver for auxiliary coolant heater -R149- is renewed, the remote control receiver for auxiliary coolant heater -R149- nee ...

Other materials:

Removing and installing heater and air conditioning unit
Special tools and workshop equipment required Torque wrench -V.A.G 1331/- (5…50 Nm) Hose clamps up to 25 mm -3094- ...

Removing and installing rear bumper aerial for entry and start system -R136-
Removing – Remove bumper cover → General body repairs, exterior; Rep. gr.63. – Lift areal -1- slightly in direction of arrow -A-. ...

Preparing fibre optic cable
Special tools and workshop equipment required Fibre optic cable repair kit -VAS 6223A- Cutting pliers -VAS 6228- ...