VW Golf manuals

Volkswagen Golf Service & Repair Manual: General description of Midtronics -INC 940- battery tester

Batteries in VW vehicles may only be charged with battery chargers approved by VW. In the USA/Canada, it is permitted for the Midtronics -INC 940- battery charger to be used.
Midtronics -INC 940- battery charger combines battery charging with a charge condition checks and a battery test.
The following charging and analysis procedures apply to all batteries, all battery installation locations (engine compartment or luggage compartment) and battery application purposes (starter battery or second/convenience battery).
Always comply with the safety regulations, the regulations for setting up the battery charger, the display menu/display buttons, LEDs and the operating procedures described in the → operating manual INC 940.
Read through → operating manual INC 940 carefully.
Refer to → No. for more information.
  WARNING
Danger of injury! Observe warning notices and safety regulations → Chapter!
No naked flames, sparking or smoking in the vicinity of batteries.
Battery charger must be switched off before cables are connected or disconnected.
Do not remove cell plugs during charging.
Overcharging sulphated batteries can lead to explosions.
Do not store precision tools in rooms where batteries are charged, as chemical reactions may cause corrosion.
  WARNING
It is not permissible to test or charge batteries whose magic eye shows light yellow. Do not slave/jump start the vehicle!
Danger of explosion when checking and charging or slave/jump starting.
These batteries must be renewed.
   
Charging battery with battery charger -VAS 5906-
  WARNING Danger of injury! Observe warning notices and safety regulations → Chapter! ...

Charging battery
Prerequisites:   WARNING It is not permissible to test or charge batteries whose magic eye shows ligh ...

Other materials:

Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
  Note On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only camshaft control valve 1 -N205- is installed. Removing Inlet camshaft control valve 1 -N205- –  Disconnect ele ...

Removing and installing lock cylinder
Special tools and workshop equipment required     Locking pin -T40011- or suitable welding wire Removing –  Remove lowe ...

Assembly overview - front door trim
  Note   The assembly overview is shown for the front door trim on driver side. The assembly overview for the front passenger side is analogous.   The assembly overview is shown for 4-door models. The assembly overview ...

© 2016-2024 Copyright www.vwgolf.org