Volkswagen Golf Service & Repair Manual: Removing and installing ESP sensor unit -G419-

Volkswagen Golf Service & Repair Manual / Brake system / ABS, ADR, TCS, EDL, ESP / Sensors / Removing and installing ESP sensor unit -G419-

The lateral acceleration sender -G200-, the yaw rate sender -G202- and the longitudinal acceleration sender -G251- are installed together with the control unit for electromechanical parking brake -J540- in the ABS control unit -J104-.

The components cannot be renewed individually.

–	Removing and installing ABS control unit -J104- → Chapter.

Assembly overview - speed sensor on rear axle, all-wheel drive

1 - ABS speed sensor Clean inside surface of hole before inserting sensor Coat inside surface with high-temperature paste -G 052 112 A3- ...

Removing and installing speed sensors on front axle -G45-/-G47

Note Removal and installation is described for the front left speed sensor. Removal and installation of the front right speed sensor is analogous. ...

Other materials:

Removing and installing oil level and oil temperature sender -G266-
Removing – Drain off engine oil. – Disconnect electrical connector -3-. – Undo nuts -1- and remove oil level and oil temp ...

Charging battery with battery charger -VAS 5906-
WARNING Danger of injury! Observe warning notices and safety regulations → Chapter! WARNING It is not permissible ...

Removing and installing rear outer belt end fitting
Removing – Unscrew bolt -1- on belt end fitting -2-. Installing The anti-rotation tab -arr ...