Removing and installing brake servo for vehicles with 1.2 l and 1.4 l petrol
engines
Note
If there are problems with the brake servo, first check the
brake servo vacuum system
→ Chapter.
Special tools and workshop equipment required
Release tool -T10159 ...
Balancing wheel, conditions
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Removing and installing right temperature flap control motor -V159-, LHD
vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...