Volkswagen Golf Service & Repair Manual: Overview of fitting locations - seat belts and anchorage points, 4-door
model
- Assembly overview
→ Chapter.
- Removing and installing
→ Chapter
| 2 - |
Front belt end anchor |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 3 - |
Front three-point seat belt |
- With front passenger seat belt tensioner igniter 1 -N154- and control
unit for front right belt tensioner -J855-
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 4 - |
Belt height adjustment |
- Assembly overview
→ Chapter.
- Removing and installing
→ Chapter
| 5 - |
Rear outer belt end fitting |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 6 - |
Rear centre belt end fitting |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
- For rear outer three-point seat belt
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
- For rear centre three-point seat belt.
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
- For rear outer three-point seat belt
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 10 - |
Belt height adjustment |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 11 - |
Rear outer belt end fitting |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
- For front three-point seat belt
- With driver seat belt tensioner igniter 1 -N153- and control unit for
front left belt tensioner -J854-
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
| 13 - |
Front belt end anchor |
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
- Assembly overview
→ Chapter
- Removing and installing
→ Chapter
1 -
Front belt buckles
Assembly overview
→ Chapter.
Removing and installing
→ Chapter
2 -
Front belt end ancho ...
1 -
Front belt buckles
Assembly overview
→ Chapter
Removing and installing
→ Chapter
2 -
Front belt end anchor ...
Other materials:
Disconnecting and connecting battery, vehicles with high-voltage system
Caution
Observe the following instructions and precautions
on safety when working on pyrotechnic components:
Contrary to the following description, the battery
must be disconnected ...
Assembly tools for single wire seals
The assembly tools serve as a means of sliding the single
wire seals fully into the contact housing without damage and
thereby assure complete sealing between single wire and contact
housing.
Four assembly tools for single wire seals are ...
Removing and installing ambient temperature sensor -G17
Note
The ambient temperature sensor -G17- is used for determining
the outside temperature and as a switch-on condition of the
auxiliary and supplementary heater via CAN bus.
–
Removing and installing ambient temper ...
© 2016-2026 Copyright www.vwgolf.org
