VW Golf manuals

Volkswagen Golf Service & Repair Manual: Mobile telephone preparation, Bluetooth car phone online

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Telephone system / Mobile telephone preparation, Bluetooth car phone online

The Bluetooth car phone is integrated in control unit 1 for information electronics -J794-.
Connection to mobile telephone -R54- is established via Bluetooth.
Aerial for Bluetooth -R152- is integrated into control unit 1 for information electronics -J794-.
A WLAN hotspot is integrated to connect WLAN devices. A corresponding mobile phone contract is prerequisite for using.
The hands-free system consists of the following components:
Display unit for control device of front display and information control panel -J685-
Control unit 1 for information electronics -J794- with aerial for Bluetooth -R152-
Telephone microphone -R38-
Aerial amplifier for mobile telephone -R86-
Fault finding is done via Guided fault finding → Vehicle diagnostic tester.
Repairing aerial wiring → Electrical System, General Information; Rep. gr.97.
Notes on Bluetooth technology
A standardised wireless connection is used for transferring data between control unit 1 for information electronics -J794- and mobile telephone -R54- - Bluetooth technology.
An additional transmitter/receiver unit is located in control unit 1 for information electronics -J794-. An aerial for Bluetooth -R152- is used to connect control unit 1 for information electronics -J794- and mobile telephone -R54- such that the mobile telephone -R54- can be operated wirelessly without wiring connection.
The transmission range amounts to approx. 10 m.
   
Mobile telephone preparation, Bluetooth hands-free system
Bluetooth hands-free system is integrated in control unit 1 for information electronics -J794-. Connection to mobile telephone -R54- is established v ...

Overview of fitting locations - telephone system
1 -  Telephone microphone -R38- In front interior light -W1-. Removing and installing → Chapter 2 -  ...

Other materials:

Operating and display unit
Overview of control and display unit 1 -  Heated driver seat regulator Optional Seat heater has 3 heat settings. Current setting is shown by LED. If no LED is lit, seat heating is switched off. 2 -  ...

Removing and installing Hall sender -G40-
Removing     –  Release hose clips -1- and -2-, and remove air pipe.   –  Disconnect electrical connector -1-. ...

Assembly overview - rear vehicle level senders, multi-link suspension, four-wheel drive
  Note The vehicle level sender is available as a replacement part only complete with coupling rod and upper and lower retaining plates. 1 -  Pop rivet nut 2 -  Electrical connector 3 -  Pop rivet ...

© 2016-2026 Copyright www.vwgolf.org