VW Golf manuals

Volkswagen Golf Service & Repair Manual: Mobile telephone preparation, Bluetooth hands-free system

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Telephone system / Mobile telephone preparation, Bluetooth hands-free system

Bluetooth hands-free system is integrated in control unit 1 for information electronics -J794-.
Connection to mobile telephone -R54- is established via Bluetooth.
Aerial for Bluetooth -R152- is integrated into control unit 1 for information electronics -J794-.
The hands-free system consists of the following components:
Display unit for control device of front display and information control panel -J685-
Control unit 1 for information electronics -J794- with aerial for Bluetooth -R152-
Telephone microphone -R38-
Aerial amplifier for mobile telephone -R86-
Fault finding is done via Guided fault finding → Vehicle diagnostic tester.
Repairing aerial wiring → Electrical System, General Information; Rep. gr.97.
Notes on Bluetooth technology
A standardised wireless connection is used for transferring data between control unit 1 for information electronics -J794- and mobile telephone -R54- - Bluetooth technology.
An additional transmitter/receiver unit is located in control unit 1 for information electronics -J794-. An aerial for Bluetooth -R152- is used to connect control unit 1 for information electronics -J794- and mobile telephone -R54- such that the mobile telephone -R54- can be operated wirelessly without wiring connection.
The transmission range amounts to approx. 10 m.
   
Telephone system
...

Mobile telephone preparation, Bluetooth car phone online
The Bluetooth car phone is integrated in control unit 1 for information electronics -J794-. Connection to mobile telephone -R54- is established via ...

Other materials:

Removing and installing lock carrier trim
Special tools and workshop equipment required         Removal lever -80 - 200 Removing Vehicles with towing bracket, saloon ...

Removing and installing airbag control unit -J23
Removing   WARNING Observe safety instructions for pyrotechnic components → Chapter.     –  ...

Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface coating are installed in the vehicle. In addition, rubber and plastic p ...

© 2016-2024 Copyright www.vwgolf.org