This chapter contains information on the following subjects:
→ Description of the central locking system
→ Locking and unlocking the vehicle from the outside→ Locking and unlocking the vehicle from the inside
→ Locking and unlocking the vehicle with→ SAFELOCK mechanism
→ Anti-theft alarm→ Interior monitoring system and anti-tow alarm
The central locking system will only work correctly when all doors and the tailgate are properly closed. The vehicle cannot be locked with the key if the driver door is open.
In vehicles with the Keyless Access locking and starting system, the vehicle can only be locked when the ignition has been switched off and the driver door is closed.
If the vehicle is unlocked and not used for a long time (e.g. in your own garage) the vehicle battery could discharge or the engine may not start.
Additional information and warnings:

WARNING
Description of the central locking systemChecking belt guide fittings and latch plates
Plastic-coated fittings show fine, parallel scoring after
stress on belt system (when belt was fastened during accident).
(On the other hand, wear caused by frequent belt use can be
recognized by smooth wear, free of lines.)
–
...
Assembly overview - gas discharge headlight with cornering light and LED
daytime running light
1 -
Headlight
Removing and installing
→ Chapter
2 -
Front turn signal bulb
Front left turn signal bulb -M5-
Front right turn signal bulb -M7-
Removing and installi ...
Removing and installing insulation
Removing
–
Lever retaining clips -2- out of bonnet
-3- using removal lever -80-200-.
–
Pull insulation -1- out of elongated
holes -arrows-.
Inst ...