VW Golf manuals

Volkswagen Golf Owners Manual: Introduction

This chapter contains information on the following subjects:

 → Vehicle identification data  

 → Engine data  

 → Dimensions  

 → Performance figures  

The vehicle data sticker in the service schedule or the vehicle registration documents show which engine is installed in your vehicle.

All data in the official vehicle documents take precedence over these data. All data in this manual apply to the basic German model. The figures may be different if additional equipment is fitted, for different models, for special vehicles and for other countries.

Additional information and warnings:

WARNING

Ignoring or exceeding the values given for the weights, payloads, vehicle dimensions and maximum speed could lead to accidents and serious injuries.
Technical data
...

Vehicle identification data
Fig. 19 A: Vehicle data sticker: example shows a vehicle with engine code CPTA ③ B: Type plate Fig. 20 Vehicle identification number First read and observe the introductory information and ...

Other materials:

Air conditioning system compressor with magnetic clutch
The air conditioner compressor is driven by a V-belt from the engine. An electromagnetic clutch is fitted to the air conditioner compressor. When the air conditioning system is switched on, it transmits the mechanical drive between the V ...

Raising wheel bearing assembly to unladen position (vehicles with coil springs), rear axle
Special tools and workshop equipment required Engine and gearbox jack -V.A.G 1383 A- Tensioning strap -T10038- Support -T10149-     Caution All bolts on run ...

Standby, Alert, and Alarm States
While in Sentry Mode, Model X may shift through three states as a response to its surroundings-Standby, Alert, and Alarm: Standby. Model X is automatically "on standby" when you activate Sentry Mode. The cameras constantly monitor the surrounding area for possible security threats. Alert. ...

© 2016-2023 Copyright www.vwgolf.org