VW Golf manuals

Volkswagen Golf Service & Repair Manual: General repair instructions

–  → Chapter „Safety precautions when working on high-voltage system“ Comply with notes.
–  Read self-diagnosis of auxiliary heater using vehicle diagnostic tester.
–  When parts of the fuel system are removed or renewed, ensure that all components for fuel delivery to the auxiliary/supplementary heater are properly installed.
–  Mark coolant hoses before removing to avoid any confusion when reconnecting.
Following repair work in the vicinity of the auxiliary/supplementary heater fuel line, check the following points:
that the fuel lines are routed flush with the vehicle underbody and are protected against mechanical damage.
that the auxiliary heater fuel line is protected from heating which might disturb operation.
that the fuel line does not come in contact with parts that become hot.
   
Identification plates
There are different types of identification plates. When the auxiliary heater is replaced, check the type plate and the duplicate plate and replace a ...

Aux. heater/heater booster
...

Other materials:

Removing and installing tank flap unit
Removing     –  Screw off tank cover. –  Remove bolt -3-. –  Slightly pull tank flap unit towards rear -arrow a- out of catches. –  Swing tan ...

Checking systems with a restrictor and collector (with internally regulated air conditioner compressor)
  Note Connecting air conditioner service station → Chapter. Observe the test prerequisites → Chapter. –  Raise engine speed to 2,000 rpm. ...

Removing and installing auxiliary heater
Special tools and workshop equipment required     Torque wrench -V.A.G 1410- (4…20 Nm)   Hose clamps, up to 25 mm -3094- ...

© 2016-2026 Copyright www.vwgolf.org