Volkswagen Golf Service & Repair Manual: General description – Start/Stop system

Volkswagen Golf Service & Repair Manual / Electrical system / Starter- current supply- CC / Start/Stop system / General description – Start/Stop system

The Start/Stop system is used for reducing fuel consumption by automatically switching off the engine when the vehicle is stationary and automatically starting it when the driver wants the vehicle to move on. The Start/Stop mode is activated automatically. In order for this to happen, the vehicle must be driven for approx. 4 seconds at a minimum speed of 3 km/h.

Start/Stop system

...

Overview of fitting locations – Start/Stop system

Note Note safety precautions → Chapter. The illustration shows fitting locations for LHD vehicles. Fittin ...

Other materials:

Trailer socket
The trailer socket must be connected in accordance with the manufacturer's instructions to the electrical system of the pulling vehicle. When installing, observe the relevant current flow diagrams and the installation instructions from t ...

Removing and installing auxiliary heater
Special tools and workshop equipment required Torque wrench -V.A.G 1410- (4…20 Nm) Hose clamps, up to 25 mm -3094- ...

Overview of fitting locations - front control motors, RHD vehicles
1 - Air recirculation flap control motor -V113- Checking: with vehicle diagnostic tester Removing and installing → Chapter Renewing: initiate basic setting using vehicle diagnostic tester. 2&nbs ...