Volkswagen Golf Owners Manual: Fitting the front towing eye

Volkswagen Golf Owners Manual / If and when / Practical tips / Tow-starting and towing / Fitting the front towing eye

Fig. 246 In the right-hand side of the front bumper: removing the cover

Fig. 247 Front bumper, right-hand side: screwing in the towing eye

First read and observe the introductory information and safety warnings

The towing eye is screwed into a threaded hole behind a cover on the right of the front bumper .

The towing eye must always be kept in the vehicle.

Comply with the notes on towing .

Fitting the towing eye at front

Remove the towing eye from the vehicle toolkit in the luggage compartment .

Press at the side of the cover (arrow) to release the cover.

Remove the cover and leave it hanging from the vehicle.

Turn the towing eye clockwise into the threaded hole and tighten as far as it will go . Use a suitable object to screw the towing eye fully and securely into the mounting.

After you have finished towing, remove the towing eye by unscrewing it anticlockwise.

Insert the side tab of the cover into the opening in the bumper.

Push down on the opposite side of the cover until the catch clicks into place in the bumper.

NOTICE

The towing eye must always be screwed firmly into the mounting. Otherwise, the towing eye can be ripped out of the mounting when the vehicle is being tow-started or towed.

Notes on towing

First read and observe the introductory information and safety warningsTow rope or tow bar It is easier and safer to tow a vehicle with a tow bar. Only use a tow rope if you do not have a tow bar ...

Fitting the rear towing eye

Fig. 248 Rear bumper on the right-hand side: removing the cover Fig. 249 Rear bumper on the right-hand side: screwing in the towing eye First read and observe the introductory information an ...

Other materials:

Removing and installing brake pads, FS III front brake
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Piston resetting appliance -T10145- ...

Winter tyres
M+S symbol On an “M and S tyre” the tread profile, tread composition or construction are designed so that the handling characteristics are improved on snow as compared with a normal tyre - especially when pulling away or stabilisatio ...

General notes
Cleanliness specifications for working on the auxiliary heater and fuel system When working on the fuel supply and injection system, pay careful attention to the following “rules”: Thoroughly clean all unions a ...