VW Golf manuals

Volkswagen Golf Service & Repair Manual: Connecting air conditioner service station for measuring and checking

Depending on the type of equipment chosen, there may be variations in the required procedure; therefore always follow the user's manual for the equipment being used.
  Note
Always follow the procedure described in the user's manual for your air conditioner service station -VAS 6007A- (or later model).
The charging hoses must only be connected according to the following work procedure to prevent air or moisture from entering the refrigerant circuit:
–  Switch off ignition.
–  Connect air conditioner service station to power supply.
–  Unscrew sealing caps from service station connections or from connections with valve (see vehicle-specific refrigerant circuit).
→ Rep. gr.87
–  Evacuate charging hose.
  Note
Connect the charging hose to the service connections of the refrigerant circuit using quick-release couplings.
  Caution
Do not open the valves in the low- or high-pressure sides when the engine is running. Otherwise, if the air conditioning is switched on, the air conditioner compressor or the air conditioner service station may be destroyed by a “short circuit” between the high- and low-pressure sides of the refrigerant circuit.
–  Turn hand wheel into quick-release coupling adapter until the valve in the service connection is definitely open (observe pressure gauge; do not over-tighten valve).
–  Start the engine and perform the planned tests and measurements.
–  Compare determined values with specifications → Chapter.
–  Before disconnecting the quick-release coupling, close it by turning out the handwheel.
   
Important notes for working with the air conditioner service station
To operate the air conditioner service station -VAS 6007A-, the following must be observed (also applies to other and latest available air conditioner service station ...

Draining refrigerant circuit using air conditioner service station
  WARNING High-voltage on high-voltage system. Danger of electric shock on air conditioner compressor! ...

Other materials:

Removing and installing shock absorber, multi-link suspension, left shock absorber
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Torque wrench -V.A.G 1410- Spring compressor -V.A.G 1752/1- Spring retainer -V.A.G 1752/3A- Adapter -V.A.G 1752/9-, not illu ...

Overview of fitting locations - front control motors, LHD vehicles
1 -  Temperature flap control motor -V68- Checking: with vehicle diagnostic tester Removing and installing → Chapter Renewing: initiate basic setting using vehicle diagnostic tester. 2 -&nbs ...

Structure of factory finish, surfacer
Surfacer, 2-door vehicles  -  Surfacer Only the coloured areas of the body are filled.         Surfacer, 4-door vehicles  -  Surfacer Only t ...

© 2016-2026 Copyright www.vwgolf.org