VW Golf manuals

Volkswagen Golf Service & Repair Manual: Cleaning off excess adhesive

–  Use adhesive remover -D 002 000. 10- as cleaning agent. Observe the appropriate safety precautions when performing this work.
  WARNING
When cleaning the vehicle interior, do not press freshly installed window outwards.
–  First clean painted surface as well as possible using a dry cloth. Remove residue using adhesive remover -D 002 000. 10-.
–  Cleaning plastic trim: allow adhesive sealant to cure (approx. one hour) and then peel off.
   
Preparing body flange for fitting
  WARNING Keep bonding surface free of dirt and grease. Do not treat bonding surface with activator ...

Windscreen
...

Other materials:

Towing a trailer
First read and observe the introductory information and safety warnings Headlight adjustment Towing a trailer can raise the front end of the vehicle enough for the dipped beam to blind other road users. Use the headlight range control to lower the light cone as required. If you do not have ...

Removing and installing fuel gauge sender -G-, vehicles with front-wheel drive
Removing –  Remove fuel delivery unit → Chapter. –  Note colour assignment of cables -1- for re-installation.     –  ...

Renewing LSU Lambda probe (6-pin)
  Note If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. The wires should not be crimped or cut as otherwise the function of the L ...

© 2016-2025 Copyright www.vwgolf.org