Volkswagen Golf Service & Repair Manual: Assembly overview - wheel, PAX
| 1 - | Wheel |
| Fitting wheels → Chapter |
| 2 - | Wheel bolts |
| Different versions → Chapter |
| 3 - | PAX tyre |
| Identification markings on the tyre sidewall → Chapter |
| 4 - | Support ring |
| 5 - | Wheel for PAX tyres |
| Observe fitting instructions → Chapter |
| 6 - | Metal valve body |
| Use only correct valves as specified in → ETKA |
| Supplied as complete unit |
| 7 - | Wheel electronics |
| Renew batteries as a complete unit |
| Remaining service life, temperature and inflation pressure can be read out via diagnosis function with vehicle diagnostic, testing and information system -VAS 5051- |
| Beru tyre pressure sensor system → Chapter |
| Siemens tyre pressure sensor system → Chapter |
| 8 - | Adhesive balancing weights |
| Not more than 60 g per wheel permitted |
| Remove dirt and grease from wheel rim at bonding point |
| Pull off backing foil |
| Bond on balancing weights at surfaces provided for this purpose |
| 9 - | Anti-theft wheel bolt |
| Observe fitting instructions → Chapter |
| Handling → Fig. |
| 10 - | Adapter for anti-theft wheel bolt |
| Fit onto wheel bolt → Fig. |
| 11 - | Cap for anti-theft wheel bolts |
| 12 - | Caps for wheel bolts |
| 13 - | Wheel bolts |
Note| Make sure the correct wheel bolts are fitted → Electronic Parts Catalogue “ETKA” |
| Observe fitting instructions → Chapter |
| 14 - | Wheel hub cover |
| Removing and installing → Chapter |
Assembly overview - standard wheel
1 -
Wheel
Fitting wheels
→ Chapter
2 -
Wheel bolts
Different versions
→ Chapter
...
Fitting tyre
...
Other materials:
Renewing LSF Lambda probe (4-pin)
Note
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified.
Do not repair Lambda probe wires, since this can result in
malfunctions.
...
Instructions for use of flanging tool
Unbolt relevant brake line at brake caliper or wheel brake
cylinder; catch escaping brake fluid and dispose of this as per
regulations.
–
Cut through brake line at a suitable point (straigh ...
Removing and installing fresh air blower control unit -J126-, LHD vehicles
Removing
–
Remove baffle plate
→ Chapter.
–
Disconnect electrical connectors -1-
and -3-.
–
Unscrew bolt ...
