Volkswagen Golf Service & Repair Manual: Assembly overview - lights in exterior mirror

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Lights in exterior mirror / Assembly overview - lights in exterior mirror

Assembly overview - lights in exterior mirror

1 -	Cover for mirror

Material: ABS

Removing and installing → General body repairs, exterior; Rep. gr.66.

2 -

Bolt

Qty. 2

Specified torque: 1.0 Nm

3 -	Turn signal

Removing and installing → Chapter

4 -

Bolt

Specified torque: 9.0 Nm

5 -

Bolt

Specified torque: 9.0 Nm

6 -

Fastener

7 -

Cap

8 -	Mirror glass

Removing and installing → General body repairs, exterior; Rep. gr.66.

9 -

Bolt

Qty. 2

Specified torque: 1.0 Nm

10 -	Mirror frame

Removing and installing → General body repairs, exterior; Rep. gr.66.

11 -

Bolt

Qty. 3

Specified torque: 1.0 Nm

12 -	Adjustment unit

Removing and installing → General body repairs, exterior; Rep. gr.66.

13 -	Entry light in exterior mirror

Driver side entry light in exterior mirror -W52-

Front passenger side entry light in exterior mirror -W53-

Removing and installing entry light in exterior mirror → Chapter.

14 -	Mirror mounting

Removing and installing → General body repairs, exterior; Rep. gr.66.

Lights in exterior mirror

...

Removing and installing turn signal

Special tools and workshop equipment required Torque wrench -V.A.G 1783- Note ...

Other materials:

Flat spots caused by hard braking
This type of flat spots may be caused by hard braking on a rough surface such as a tarmac road. During this type of braking manoeuvre only a certain area of the tyre is abraded accordingly and therefore causes an imbala ...

Removing and installing rear interior light/reading light
Removing Caution Danger of damage to component surfaces. When using leverage tools, mask visible areas of the component with commercially available adhesive tape. ...

Repair instructions
Contact corrosion Contact corrosion can occur if unsuitable fastening elements (screws, bolts, nuts, washers) are used. For this reason, only connecting elements with a special surface coating have been fitted. In addit ...