First read and observe the introductory information
and safety warnings
Volkswagen recommends that you seek advice from a Volkswagen dealership before purchasing accessories, spare parts or service fluids. For example, if the vehicle is to be retrofitted with accessories or if parts have to be renewed. Volkswagen dealerships can recommend accessories, parts and service fluids suitable for your requirements. They can also answer any questions you might have regarding official regulations.
Volkswagen recommends that you only use approved Volkswagen accessories and Volkswagen Genuine Parts® . These parts and accessories have been specially tested by Volkswagen for suitability, reliability and safety. And Volkswagen dealerships are qualified to install them correctly.
Although the market is constantly scrutinised, Volkswagen cannot assume responsibility for the reliability, safety and suitability of products Volkswagen has not approved. Volkswagen can therefore assume no responsibility for these parts, even if they have been approved by an official testing agency or are covered by an official approval certificate.
Any retro-fitted equipment that has a direct effect on the vehicle and/or the way it is driven must be approved by Volkswagen for use in your vehicle and bear the e mark (the European Union's authorization symbol). These devices include cruise control systems or an electronically controlled suspension.
Any additional electrical components fitted that do not serve
to control the vehicle itself must bear the
mark (manufacturer conformity declaration
in the European Union). Such devices include refrigerator boxes, laptops and ventilator
fans.
WARNING
Removing and installing high-level brake light, GTI, GTD and
»R«
Removing:
–
Remove roof spoiler
→ General body repairs, exterior; Rep. gr.66.
–
Unscrew bolts -1-,
-5- and -6-
from high-level brak ...
Removing and installing high-voltage heater (PTC) -Z115- / high-voltage
heater (PTC) -J848
Special tools and workshop equipment
required
Commercially available Torx socket bit “TS30H” with hole in
front face
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122- ...
Removing and installing damper weight for refrigerant line, low-pressure
side
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
Removing
–
Observe safety precautions when working in the ...