First read and observe the introductory information
and safety warnings
| Display | Possible cause | Solution |
|---|---|---|
|
Bonnet not closed properly | Do not drive
on! Close bonnet. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
A symbol
in the instrument cluster display indicates
that the bonnet is open or not closed properly. These symbols are also visible when
the ignition is switched off. The display will go out approximately 15 seconds after
all doors have been closed and the vehicle has been locked.

WARNING
The symbol can differ depending on the version of the instrument cluster.
Introduction
Preparing the vehicle for working in the engine compartmentDetecting leaks
External damage can cause leaks in the refrigerant circuit. Because a small
leak will involve only small quantities of refrigerant, leaks should be checked
for using an electronic leak detector or by introducing a leak detection
additive to the refrigerant circuit. Electronic leak detectors ca ...
Assembly overview - door handle and door lock
Note
Only the left side is shown. The right side is similar.
1 -
Door lock
Removing and installing
→ Chapter
2 -
Bolt
1.5 Nm
For locking bar in door handle bracket
3 -
...
Removing and installing rear door window
Removing
–
Remove rear door trim
→ General body repairs, interior; Rep. gr.70.
–
Remove inner door cover -8-.
–
Lower door window -9- until sp ...