VW Golf manuals

Volkswagen Golf Service & Repair Manual: Run-flat tyres, PAX, inflating tyre

Observe the following important points when inflating the tyre:
–  Only inflate after fitting the tyre with valve core installed. Check whether the beads have properly seated at 1 bar.
–  If one of the beads is not seated properly, do not let air out of the tyre, but apply the fitting roller to the appropriate bead and press on lightly while turning. The bead will then seat itself properly.
   
–  Then fill up with air until the specified inflation pressure for the vehicle is reached. Tyre gas for standard tyres can also be used.
  Note
Do NOT overfill tyre (e.g. up to 3.5 bar), even briefly, as is permissible with standard tyres.
 

Run-flat tyres, PAX, inflating tyre

Run-flat tyres, PAX
...

Run-flat tyres, PAX, wheel alignment
The procedure for adjusting the wheel alignment on vehicles with run-flat tyres (PAX) is the same as for vehicles with standard tyres. Generall ...

Other materials:

Removing and installing hazard warning light switch -EX3-
Removing     –  Grasp front passenger side airbag deactivated warning lamp -K145--1- at sides -arrows A- and pull it out of dash panel. –  Disconnect ele ...

Purging (cleaning) refrigerant circuit with refrigerant R134a
Vehicles with high-voltage system (hybrid vehicles) Observe the additional warning instructions for working on vehicles with high-voltage system → Electrical system; Rep. gr.93.   ...

Removing and installing brake master cylinder, RHD vehicles
  Note If there are problems with the brake servo, first check the brake servo vacuum system → Chapter. Special tools and workshop equipment required     ...

© 2016-2026 Copyright www.vwgolf.org