Volkswagen Golf Service & Repair Manual: Renewing Lambda probe

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Wiring / Renewing Lambda probe

Note

Do not repair Lambda probe wires, since this can result in malfunctions.

If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified.

Identify the lambda probe by way of the protective tube as required → Chapter.

Anti-corrosion treatment

Caution Missing anti-corrosion treatment results in damage to the onboard supply. &nbs ...

Renewing LSF Lambda probe (4-pin)

Note If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. ...

Other materials:

Assembly overview - data bus diagnostic interface
1 - Electrical connector For data bus diagnostic interface -J533- 2 - Data bus diagnostic interface -J533- Removing and installing → Chapter 3 - Bolt Spe ...

Removing and installing backrest release mechanism
Removing – Remove backrest cover and backrest padding → Chapter. – Pull operating lever -1- upwards and unscrew bolt -2-. ...

Removing and installing tail light bulb -M2-/-M4-
Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. Removing – Turn light switch to “0” position. ...