First read and observe the introductory information
and safety warnings
Assembly overview - wheel bearing assembly, torsion beam axle
1 -
Dust cap
Renew after removing
Pressing off and driving in
→ Chapter
A proper seal can be achieved only by installing a new dust cap.
2 -
Bolt
Renew after remov ...
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Assembly overview - manually operated anti-dazzle interior mirror, without
rain and light sensor -G397- and front camera for driver assist systems -R242-
1 -
Retaining plate
Retaining plate for mirror base
Glued to windscreen
Removing and installing
→ Chapter
2 -
Interior mirror
Manually operated
Removing and installing
→ Chapter
...