This chapter contains information on the following subjects:
→ Warning lamp and coolant temperature display
→ Coolant specification→ Checking the coolant level and refilling coolant
Never carry out any work on the engine coolant system if you are not familiar with the requisite procedures, or if you do not have access to the correct tools, operating equipment and fluids . The work should be carried out by a qualified workshop if you are uncertain. Volkswagen recommends using a Volkswagen dealership for this purpose.
Serious injuries can be caused if work is carried out incorrectly.
Additional information and warnings:

WARNING
Coolant and coolant additives can pollute the environment. Spilt operating fluids must be collected and disposed of properly and with respect for the environment.
Coolant
Warning lamp and coolant temperature displayRemoving and installing exterior mirror adjuster -EX11-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar.
Removing
Caution
Danger o ...
Removing and installing drive shaft, left drive shaft, constant velocity
joints VL100 and VL107, e-Golf
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
Separating cover and padding for rear seat backrest
Special tools and workshop equipment
required
Upholstery clip pliers -V.A.G 1634
Removing
–
Remove backrest cover with bac ...