VW Golf manuals

Volkswagen Golf Owners Manual: Introduction

This chapter contains information on the following subjects:

 → Controls for the air conditioning system  

 → Operation via the infotainment system  

 → Controls for the heating and fresh air system  

 → Information on the air conditioning system  

 → Vents  

 → Air recirculation mode  

The dust and pollen filter

The dust and pollen filter with activated charcoal reduces the level of impurities in the outside air entering the vehicle.

The dust and pollen filter must be changed regularly to avoid impairing the performance of the air conditioning system.

The dust and pollen filter must be changed more frequently than stated in the service schedule if the efficiency of the filter declines prematurely due to the vehicle being used in areas with high levels of air pollution.

Additional information and warnings:

WARNING

Poor visibility through all windows increases the risk of collisions and accidents, which can cause serious injuries.

WARNING

Stale air can quickly make the driver tired and affect their concentration, which in turn can cause collisions, accidents and serious injuries.

NOTICE

If the cooling system is switched off, the outside air that is drawn into the vehicle is not dehumidified. To prevent the windows misting over, Volkswagen recommends that you leave the air conditioning (compressor) switched on. Press the button. The indicator lamp in the button must light up.

Maximum heat output, which is needed to defrost the windows as quickly as possible, is only available when the engine has reached its operating temperature.

Keep the air intake slots in front of the windscreen free of snow, ice and leaves to ensure heating and cooling is not impaired, and to prevent the windows from misting over.

Heating, ventilating, cooling
...

Controls for the air conditioning system
Fig. 181 In the centre console: air conditioning controls (manual) Fig. 182 In the centre console: Climatronic controls First read and observe the introductory information and safety warning ...

Other materials:

Front airbags
Fig. 70 Location and deployment zone of the driver front airbag Fig. 71 Location and deployment zone of the front passenger front airbag First read and observe the introductory information and safety warnings In conjunction with the seat belts, the front airbag system gives the front o ...

Overview of fitting locations - front control motors, RHD vehicles
1 -  Air recirculation flap control motor -V113- Checking: with vehicle diagnostic tester Removing and installing → Chapter Renewing: initiate basic setting using vehicle diagnostic tester. 2&nbs ...

Contact surface cleaning set -VAS 6410-
Using contact surface cleaning set -VAS 6410- The contact surface cleaning set -VAS 6410- allows optimal repair quality to be achieved in the area of vehicle electrics. The tools allow performing repair work in the area of the sensor in wiring harnesses for t ...

© 2016-2026 Copyright www.vwgolf.org