First read and observe the introductory information
and safety warnings
The immobilizer helps to prevent the engine from being started and driven with an unauthorised vehicle key.
There is a chip in the key. It automatically deactivates the immobilizer when the vehicle key is inserted into the ignition lock.
The electronic immobilizer is automatically activated when the vehicle key is removed from the ignition lock. In vehicles with Keyless Access, the vehicle key must be outside the vehicle .
The engine can only be started using a genuine Volkswagen vehicle key with the correct code. Coded vehicle keys are available from a Volkswagen dealership .
If a non-authorised vehicle key has been used, this will be displayed in the instrument cluster. The vehicle cannot be used if this occurs.
The vehicle cannot be operated properly if you do not have a genuine Volkswagen key.
Stopping the engine
Engine preheatingRemoving and installing brake servo, LHD vehicles
Note
If there are problems with the brake servo, first check the
brake servo vacuum system
→ Chapter.
Special tools and workshop equipment
required
...
Assembly overview - speed sensor on rear axle
1 -
ABS speed sensor
Before inserting sensor, clean inner surface of fitting hole and
coat it with high-temperature paste -G 052 112 A3-.
Removing and installing
→ Chapter
2 -
Bolt
...
Removing and installing -J245-sliding sunroof adjustment control unit
Special tools and workshop equipment
required
Removing
Torque wrench -V.A.G 1783-
–
Remove glass panel
→ Chapter.
...