First read and observe the introductory information
and safety warnings
Towing requires some experience, especially when using a tow rope. Both drivers should be familiar with the technique required for towing. Inexperienced drivers should not attempt to tow.
When driving, ensure that you do not pull too hard on the towing vehicle and take care to avoid jerking movements. When towing on an unpaved road, there is always a risk of overloading and damaging the anchorage points.
You can still use the turn signals if your vehicle is towed with the hazard warning lights and ignition switched on. Move the turn signal lever to signal the required direction. The hazard warning lights will not flash while the turn signal is being used. The hazard warning lights will start flashing automatically as soon as the turn signal lever is moved back to the neutral position.
Notes for the driver of the towed vehicle:
Notes for the driver of the towing vehicle
Fitting the rear towing eyeAssembly overview - drive shaft, constant velocity joint VL107
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
Repairing lock carrier. Right headlight mounting
Note
Line -3- indicates the position
where the tab might break off.
–
Remove front bumper cover
→ Chapter.
–
Remove headlights
→ Electrical system; Rep. gr.94.
–
...
Removing and installing centre underbody covers
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
Unclip spreader river -2- and remove
centre underbody panels.
Installing
Installation is carried out in reverse ...