Volkswagen Golf Owners Manual: Checklist

Volkswagen Golf Owners Manual / Before the journey / Sitting correctly and safely / Seat belts / Checklist

Using seat belts :

Check the condition of all seat belts regularly.
Keep the seat belts clean.
Never let any foreign bodies and liquids get on to the seat belt, the latch plate or into the slot for the seat belt buckle.
Do not trap or damage the seat belt and latch plate, for example when closing the door.
Never remove, modify or repair the seat belt or any part of the belt fixture system.
Always fasten the seat belt correctly before every journey and keep it fastened while the vehicle is in motion.

Twisted seat belt

If it is difficult to remove the seat belt from the belt guide, the seat belt may have become twisted if it was returned too quickly into the side trim:

Take hold of the latch plate then slowly and carefully pull out the seat belt.

Untwist the seat belt and guide it back slowly by hand.

Fasten the seat belt even if you are unable to undo the twist. However, the twist should not be in part of the seat belt that comes into direct contact with the body. The twist should be corrected immediately by a qualified workshop.

WARNING

Using seat belts incorrectly increases the risk of severe or fatal injuries.

Regularly check to see if the seat belt and its related parts are in perfect condition.

Always keep the seat belt clean.

Do not allow the belt webbing to become jammed, damaged or to rub on any sharp edges.

Always keep the latch plate and slot in the buckle free from foreign bodies and liquids.

Using seat belts

First read and observe the introductory information and safety warnings ...

Fastening and unfastening seat belts

Fig. 64 Inserting the seat belt latch plate into the buckle Fig. 65 Removing the latch plate from the buckle First read and observe the introductory information and safety warnings During ...

Other materials:

Safety precautions when working on cooling system
Risk of scalding due to hot coolant The cooling system is under pressure when the engine is hot. Hot steam/hot coolant can escape - risk of scalding. – Wear protective gloves. – Wear eye protection. – ...

Removing and installing lumbar support adjustment motor -V125-/-V126-/-V129-/-V130-
Special tools and workshop equipment required Special pop rivet pliers -V.A.G 1753B- Hand drill Safety goggles ...

Warning and indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Gearbox fault. Do not drive on! Move the selector lever to position P and leave the gearbox to cool down. If ...