VW Golf manuals

Volkswagen Golf Service & Repair Manual: Charging battery in maintenance mode with battery charger -VAS 5903-

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Starter- current supply- CC / Charging battery / Charging battery in maintenance mode with battery charger -VAS 5903-

  Note
When a battery is being charged in the maintenance mode and an electrical consumer draws current from the battery, the battery charger -VAS 5903- automatically compensates the charge.
The maintenance mode can be continued for an unlimited period.
The battery is always ready for use.
Observe battery manufacture's maintenance instructions!
  WARNING
Danger of injury! Observe warning notices and safety regulations → Chapter!
  WARNING
It is not permissible to test or charge batteries whose magic eye shows light yellow. Do not slave/jump start the vehicle!
Danger of explosion when checking and charging or slave/jump starting.
These batteries must be renewed.
When the battery is fully charged the battery charger -VAS 5903- switches to maintenance mode.
–  Proceed as for charging battery → Chapter.
   
At a charge condition of 100% all bars appear in display.
 

Charging battery in maintenance mode with battery charger -VAS 5903-

Charging battery in support mode with battery charger -VAS 5903-
General notes: The support mode provides the onboard supply with power when the battery is removed or disconnected. For furthe ...

General description
Battery charger - VAS 5906-   WARNING Danger of injury! Observe warning notices and safety regulation ...

Other materials:

Main beam assist
First read and observe the introductory information and safety warnings Main beam assist (Light Assist) Within the limits of the system, the main beam assist automatically switches the main beam on at speeds of over approximately 60 km/h (37 mph), depending on environmental and traffic con ...

Removing and installing door inner seal
During production, a sealant is applied to the door inner seals, which are then placed on the door flange and rolled on.   Note When removing the seal, the sealant is distributed across the inside of the seal. The sides are bent upwards ...

Connecting brake pedal to brake servo
  Hold ball head of plunger rod in front of mounting and push brake pedal in direction of brake servo, so that the ball head clicks into place. –  Check engagement by pulling briefly on brake pedal. ...

© 2016-2024 Copyright www.vwgolf.org