Volkswagen Golf Service & Repair Manual: Battery terminal connection

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Starter- current supply- CC / Battery / Battery terminal connection

WARNING

Danger of injury! Observe warning notices and safety regulations → Chapter!

Caution

To prevent damage to the battery clamps and battery terminals, the following should be observed:

The battery clamps should only be fitted by hand and without using force.

Battery terminals should not be coated with grease.

The battery clamps should be fitted so that the battery terminal is either flush with the clamp or protruding from it.

Once the battery clamps have been tightened to the specified torque, the threaded connections should not be tightened any further.

Working on airbag system

WARNING When work is performed on the airbag system (pyrotechnical components, airbag control unit -J234-, wiring) ...

Checking battery

WARNING Danger of injury! Observe warning notices and safety regulations → Chapter! ...

Other materials:

Loosening and tightening threaded connections of drive shaft
Special tools and workshop equipment required Socket, 24 mm -T10361A- Angle wrench -V.A.G 1756 A- ...

Uprated shock absorbers and coil springs
Diving or dipping of the rear end between pulling vehicle and trailer can be avoided with the use of uprated shock absorbers and coil springs on the rear axle. These shock absorbers and springs can also be retrofitted in many cases by a Volkswagen worksh ...

Assembly overview – underbody covers, petrol/diesel
1 - Front cover Left and right Removing and installing → Chapter 2 - Underbody cover Left and right Removing and installing → Chapter 3 - Nut With captive Qty. 7 on ...