Volkswagen Golf Service & Repair Manual: Sliding sunroof
- Assembly overview - sliding sunroof
- Assembly overview - sunroof roller blind
- Removing and installing sliding sunroof frame
- Removing and installing wind deflector
- Adjusting glass panel
- Removing and installing guide plate
- Removing and installing front trim for sliding sunroof
- Removing and installing -J245-sliding sunroof adjustment control unit
- Closing sunroof by hand
- Removing and installing sunroof roller blind
- Programming sliding sunroof adjustment control unit -J245-
Sliding roof
...
Assembly overview - sliding sunroof
1 -
Glass panel for panorama tilting sunroof (single pane safety glass)
Removing glass panel
→ Chapter
If drive defective, remove glass panel
...
Other materials:
Separating and connecting Bowden cable for remote release mechanism for seat
backrest
Note
The separating and connecting procedures are described for
the left side of the vehicle. The separating and connecting
procedures on the right side are analogous.
Detaching
...
Removing and installing dip beam screen motor -V294-/-V295
Note
Left dip beam screen motor -V294- and right dip beam screen
motor -V295- are only fitted on gas discharge headlights without
cornering light.
The dip beam screen motor is located in the headlight and
canno ...
Assembly overview - speed sensor on front axle
1 -
ABS speed sensor
Before inserting sensor, clean inner surface of fitting hole and
coat it with high-temperature paste -G 052 112 A3-.
Removing and installing
→ Chapter
2 -
Bolt
...