VW Golf manuals

Volkswagen Golf Service & Repair Manual: Safety precautions when using test and measuring equipment during a road test

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Technical data / Safety instructions / Safety precautions when using test and measuring equipment during a road test

Observe the following if test and measuring equipment is required during a road test:
  WARNING
Accident hazard as a result of distraction and inadequate securing of test and measuring equipment.
Danger as a result of activation of front passenger airbag in event of an accident.
Operation of test and measuring equipment while driving results in distraction.
Greater injury hazard as a result of unsecured test and measuring equipment.
Always secure test and measuring equipment to the rear seat with a strap and have it operated from there by a second person.
   
Notes on tow-starting/towing
  Caution
Danger of irreparable damage to gearbox.
Selector lever must be in “N” position for towing vehicle. Do not tow for more than 50 km and not faster than 50 km/h.
  Note
It is not possible to tow-start the engine.
   
Safety precautions when working on vehicles with a Start/Stop system
During work on vehicles with Start/Stop system, observe the following:   WARNING Injury hazard as a res ...

Identification
Gearbox identification The following information is indicated on the gearbox (example): KHN = Gearbox code 01.06.06 = Production date 1 ...

Other materials:

Removing and installing brake caliper
Special tools and workshop equipment required Vehicle diagnosis, testing and information system -VAS 5051- Tool set for brake bleeding -VAS 6564- Insert tool with ratchet -VAS 6784- Bit attachment (7 mm) -T10503- ...

Assembly overview - interior monitoring, RHD vehicles
1 -  Button for deactivating interior monitoring and vehicle inclination sensor -E616- Removing and installing → Chapter 2 -  Anti-theft alarm system sensor -G578- Removing and installing  ...

Repairs to CAN bus wiring
  An unshielded two-wire line -1- and -2- with a cross section of 0.35 mm2 or 0.5 mm2 is used for CAN bus wiring. The colour codes of the CAN bus wiring can be gleaned from the following table:   ...

© 2016-2021 Copyright www.vwgolf.org