Volkswagen Golf Service & Repair Manual: Safety precautions during road tests in which test and measuring equipment
is used
| Safety precautions during road tests in which test
and measuring equipment is used |
| Risk of injury due to unsecured test and measuring equipment |
| If a front passenger airbag is triggered during an accident,
unsecured test and measuring equipment can become dangerous projectiles. |
| – |
Secure test and measuring equipment with seat belts on the rear
seat. |
| – |
Have a second person operate test and measuring equipment on the
rear seat. |
Safety precautions when working on vehicles with a Start/Stop system
| Risk of injury due to unexpected engine start-up |
| In the case of vehicles with activated Start/Stop system, the engine
may start up unexpectedly. The status of the Start/Stop system is
indicated by a message in the dash panel insert. |
| – |
Deactivate Start/Stop system by switching off the ignition. |
Risk of injury due to highly-pressurised fuel.
The fuel system is under high pressure. Risk of injury due to fuel
which may spurt out.
–
Release high p ...
Engine number, engine data
Engine code
CJZA
CJZB
CYVA
CYVB
CHPA
CMBA
Emission standards
EU 5 plus
EU 5 plus
EU 6
EU 6
EU ...
Other materials:
Charging devices that do not require a permit
Charging devices that do not require a permit are mobile
charging devices into which pressurised gases are charged into
compressed gas containers for exclusive use of one company.
Note:
Some air conditioner service devic ...
Side airbags
Fig. 73 On the left-hand side of the vehicle:
deployment zones of side airbags (variant A). On the side of the front seat: location
and deployment range of the side airbag (variant B)
First read and observe the introductory information
and safety warnings The side airbags are located in th ...
Removing and installing vacuum sender -G608
Note
The vacuum sender -G608- is only installed in selected
petrol engines.
Removing
On »R« vehicles:
–
Open clamp -2- and screw-typ ...
© 2016-2025 Copyright www.vwgolf.org
Safety precautions when working on fuel supply system
Identification