Volkswagen Golf Service & Repair Manual: Safety instructions for using extraction and charging equipment
| Before connecting the charging system to the air
conditioning system, make sure that all existing shut-off valves
are closed. |
| Before the charging equipment is decoupled from the air
conditioning system, ensure that the process has finished. The
reason for this is to ensure that no refrigerant oil escapes
into the atmosphere. |
| After the cleaned refrigerant from the charging system has
been charged into an external pressurised gas cylinder, close
the hand shut-off valves on the bottle and the charging system. |
| Do not expose charging system to moisture or use it in a wet
environment. |
| Before performing service work and the charging system,
disconnect the current supply. |
| To reduce danger of fire, avoid using extension cords. If
nevertheless it is necessary to use an extension cable, use an
extension cable with a cross-section of at least 2.5 mm2.
|
| In case of fire, remove external cylinder. |
| If entrained oil from the air conditioning system suction
accumulator is trapped in the measuring beaker supplied, be sure
subsequently to pour the oil into a container that can be
sealed, since the oil contains a small amount of refrigerant.
Refrigerants must not be released into the environment. |
| When the air conditioner service station is switched off, it
must be secured against rolling away. |
|
|
|
Secure vessels against falling over!
Secure standing cylinders against falling over and lying
cylinders from rolling away.
...
Air conditioning service station -VAS 6007A- (and further
service stations currently available)
→ Workshop equipment
...
Other materials:
Driving through water on roads
First read and observe the introductory information
and safety warnings Please follow these rules to help prevent damage to your
vehicle when driving through water, for example if the road is flooded:
Check the depth of the water before driving through it. The water level
must be no hi ...
Uprated shock absorbers and coil springs
Diving or dipping of the rear end between pulling vehicle
and trailer can be avoided with the use of uprated shock
absorbers and coil springs on the rear axle. These shock
absorbers and springs can also be retrofitted in many cases by a
Volkswagen worksh ...
Removing and installing ignition/starter switch
Removing
–
Remove lower steering column trim
→ General body repairs, interior; Rep. gr.68.
–
Disconnect electrical connector -1-.
...
© 2016-2026 Copyright www.vwgolf.org
Handling pressure tanks
Safety precautions for when working on vehicles with air conditioning and
when handling refrigerant R134a