Volkswagen Golf Service & Repair Manual: Removing and installing inner door handle

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Rear door trims / Removing and installing inner door handle

The inner door handle is clipped into trim panel.

Note

Removal and installation are described for the trim panel on driver side. Follow same instructions for the front passenger side as appropriate.

Removing

–	Remove rear door trim → Chapter.

–	Remove trim panel → Chapter.

–	Carefully unclip inner door handle out of fasteners in trim panel all around.

Installing

Installation is carried out in reverse order.

Removing and installing trim panel

Note Removal and installation are described for the trim panel on driver side. Follow same instructions for the front passenger side as appropriate. ...

Dash panel

...

Other materials:

Introduction
This chapter contains information on the following subjects: → Warning lamp → Preparing the vehicle for working in the engine compartment → Opening and closing the bonnet Always park the vehicle on a level and stable surface before carrying out any work in ...

Overview of fitting locations - components not located in passenger compartment, Golf LHD
1 - Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter 2 - Ambient temperature sensor -G17- Removing and installing ...

Assembly overview - speed sensor on front axle
1 - ABS speed sensor Before inserting sensor, clean inner surface of fitting hole and coat it with high-temperature paste -G 052 112 A3-. Removing and installing → Chapter 2 - Bolt ...