Volkswagen Golf Service & Repair Manual: Overview of fitting locations - aerial systems
| 1 - | Frequency modulation (FM) frequency filter in positive wire -R179- |
| On window frame to the left of the rear lid |
| FM trap circuit (+) |
| Has the task of preventing the aerial signals being shorted to earth |
| Removing and installing → Chapter. |
| 2 - | Aerial amplifier 2 -R93- |
| On rear lid (bottom right) |
| Belongs to TV aerial 2 -R56-. |
| Impedance converter TV 2 |
| Removing and installing → Chapter. |
| 3 - | Amplitude modulation (AM) frequency filter -R177- |
| On rear lid (bottom right) |
| Has the task of preventing the aerial signals being shorted to earth |
| Removing and installing → Chapter. |
| 4 - | Frequency modulation (FM) frequency filter in negative wire -R178- |
| On window frame to the right of the rear lid |
| FM trap circuit (-) |
| Has the task of preventing the aerial signals being shorted to earth |
| Removing and installing → Chapter. |
| 5 - | Aerial amplifier 3 -R84- |
| On rear lid (top right) |
| Belongs to radio aerial -R248-. |
| Belongs to TV aerial 1 -R55-. |
| Impedance converter AM/FM1/TV1 |
| Removing and installing → Chapter. |
| 6 - | Aerial amplifier -R24- |
| On rear lid (top left) |
| Belongs to radio aerial -R248-. |
| Belongs to digital radio aerial -R183-. |
| Impedance converter FM2/DAB |
| Removing and installing → Chapter. |
| 7 - | Roof aerial -RX5- |
| Depending on vehicle equipment: |
| GPS aerial -R50- |
| Auxiliary heater aerial -R182- |
| GSM aerial -R205- |
| Removing and installing → Chapter |
Aerial systems
...
Removing and installing aerial amplifier -R24-/-R93-/-R84-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Note
...
Other materials:
Overview of fitting locations – adaptive cruise control, variant 1
1 -
Trim for radar sensor
2 -
Adaptive cruise control unit -J428-
Removing and installing
→ Chapter
Calibrating
→ Chapter
3 -
Bolt
Qty. 2
...
Checking adjustment of assembly mountings (engine and gearbox mountings)
Procedure
The following specifications must be obtained:
There must be a distance of -a-
= 10 mm between engine support -2-
and engine mounting -1-.
...
Automatic gearbox: selecting a gear
Fig. 136 Left-hand drive vehicles: selector
lever for automatic gearbox with lock button (arrow)
Fig. 137 Right-hand drive vehicles: selector
lever for automatic gearbox with lock button (arrow)
First read and observe the introductory information
and safety warnings The selector lever is ...
