This chapter contains information on the following subjects:
→ Running-in
→ Accessories and parts→ Service fluids and consumables
→ Repairs and technical modifications→ Repairs and faults in the airbag system
→ Retrofitting two-way radios→ Information stored in the control units
→ Using a mobile telephone in the vehicle without a connection to the external aerial→ Vehicle lifting points
→ Rodent proofingAdditional information and warnings:

WARNING
Running-inRemoving and installing front body acceleration senders -G341-/-G342-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Pull seal off entire length of plenum chamber cover.
...
Assembly overview - brake pedal, RHD vehicles
Note
The handbrake pedal travel must not be restricted by additional
floor coverings.
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry.
1 -
Bolt
20 Nm
2 -
...
Assembly overview - FS III front brake
Note
After every brake pad change, depress brake pedal firmly several
times with vehicle stationary, so that brake pads are properly seated in
their normal operating position.
Use the brake filling and bleeding equipment -VAS 5234- to draw off
brake ...