VW Golf manuals

Volkswagen Golf Owners Manual: Display and warning and indicator lamp

Volkswagen Golf Owners Manual / While driving / Driver assist systems / Speed limiter / Display and warning and indicator lamp

Fig. 163 In the instrument cluster display: speed limiter status displays

First read and observe the introductory information and safety warnings

Speed limiter displays

Status  :

  1. The speed limiter is active. The last stored speed is displayed in large digits.
  2. The speed limiter is inactive. The last stored speed is shown in small digits or the display is darkened.
  3. The speed limiter is switched off. The total mileage is displayed.

Warning and indicator lamp

Lights up or flashes Possible cause
Lit up: the speed limiter is switched on, active.
Flashing: the set speed of the speed limiter has been exceeded.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

Displays can vary as different versions of the instrument cluster are available.

If the CCS, ACC or speed limiter were switched on when the ignition was switched off, the CCS or ACC will be switched on automatically the next time the ignition is switched on. However, no speed is stored. The speed limiter's last set speed remains stored.
Introduction
This chapter contains information on the following subjects:  → Display and warning and indicator lamp    → Operating the speed limiter   The speed limiter helps the driver not t ...

Operating the speed limiter
Fig. 164 Left-hand side of the steering column: switch and buttons for operating the speed limiter Fig. 165 Left-hand side of the multifunction steering wheel: buttons for operating the speed li ...

Other materials:

Removing and installing short centre underbody cover
  Note The removal and installation procedures may have to be modified slightly depending on engine fitted. Removing Unclip spreader river -2- and remove centre underbody panels. –  Remove bolt -3-. Installi ...

Removing and installing coolant temperature sender at radiator outlet -G83
Removing Engine cold     –  Briefly open cap of coolant expansion tank -arrow- in order to release residual pressure in the cooling system, then tighten the cap ...

Removing and installing door handle
  Note Removal and installation are described only for the right door handle. The right side is similar. Removing     General information and work instructions for the door handle ke ...

© 2016-2026 Copyright www.vwgolf.org