First read and observe the introductory information and safety warnings
The individual manufacturer declares herewith that the following products conform, at the time of vehicle production, with the basic requirements and other relevant laws and regulations, including FCC Part 15.19, FCC Part 15.21 and RSS-Gen Issue 1:
Radio-based equipment
Electrical equipment
Emptying fuel tank if it is less than 3/4
full
Special tools and workshop equipment required
Removal wedge -3409-
Wrench -T10202-
Torque wrench -V.A.G 1332-
Fuel extractor -VAS 5190-
Fuel extractor -VAS 5190 A- for E 85 fuel (not shown).
&nb ...
Operating and display unit
Overview of control and display unit
1 -
Heated driver seat regulator
Optional
Seat heater has 3 heat settings. Current setting is shown by LED.
If no LED is lit, seat heating is switched off.
2 -
...
Overview of fitting locations - fuel supply system, Golf and Golf GTE
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater d ...