Volkswagen Golf Service & Repair Manual: Conducting a road test before balancing wheels

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Wheels, tyres, axle align / Vibration due to wheels/tyres - causes and rectification / Conducting a road test before balancing wheels

If a customer brings a vehicle to the workshop complaining about “vibration”, a road test is essential prior to balancing the wheels.

This will give you information about the nature of the vibration.

You will be able to determine the speed range in which vibration occurs.

–	Raise the vehicle on a lifting platform immediately after the road test.

–	Mark installation position on tyre.

Tyre position	Marked with …
Front left tyre	FL
Front right tyre	FR
Rear left tyre	RL
Rear right tyre	RR

–	Remove wheels.

–	Balance wheels.

Causes of vibration

Vibration can have a number of different causes. Vibration can also be caused by tyre wear. Tyre wear caused by driving is not always evenly spread across the entire ...

Balancing wheel, conditions

Before you start balancing the wheels, the following requirements must be met. Tyre pressure must be OK. Tread mus ...

Other materials:

Removing and installing rear parking aid senders
Removing Outer rear senders: Note The outer rear parking aid senders can be removed and installed without the need to remove the rear bumper. –&nb ...

Assembly overview - gas discharge headlight with dynamic high beam control and LED daytime running light
1 - Headlight Removing and installing → Chapter 2 - Front turn signal bulb Front left turn signal bulb -M5- Front right turn signal bulb -M7- Removing and installi ...

Removing and installing intermittent wiper switch -E22-
Note The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column combination switch -E595-. These switches cannot be separated. ...