Operation
Filling the tankChecking adjustment of assembly mountings (engine and gearbox mountings)
Procedure
The following specifications must be obtained:
There must be a distance of -a-
= 10 mm between engine support -2-
and engine mounting -1-.
...
Removing and installing inner door cover
Special tools and workshop equipment
required
Note
Removal and installation are described only for the left
cover. The right side is similar.
Removing
...
General notes
Cleanliness specifications for working on
the auxiliary heater and fuel system
When working on the fuel supply and injection system, pay
careful attention to the following “rules”:
Thoroughly clean all unions a ...