Body areas exposed to stone chipping
Note| The marked areas are exposed to stone chipping. |
| When sanding these areas, note thicknesses of the paint structure and avoid sanding through. This is the only way to ensure long-term corrosion protection. |
| – | It is recommended to carefully sand the marked area by hand to avoid “sanding through” the cathodic dip primer. |
| Body overview, 2-door |

Note| The marked areas are exposed to stone chipping. |
| When sanding these areas, note thicknesses of the paint structure and avoid sanding through. This is the only way to ensure long-term corrosion protection. |
| – | It is recommended to carefully sand the marked area by hand to avoid “sanding through” the cathodic dip primer. |
| Body overview, 4-door |

Structure of factory finish, clear coat
Masking areasRemoving and installing headlight dipped beam bulb (dual halogen headlights)
Note
Left headlight dipped beam bulb -M29- and right headlight
dipped beam bulb -M31- are only fitted on dual halogen
headlights.
Removal and installation are described for the left side.
Removal and installati ...
Removing and installing coolant temperature sender -G62
Removing
Engine cold
–
Briefly open cap of coolant expansion tank
-arrow- in order to release
residual pressure in the cooling system, then tighten the cap
...
Possible complaints about refrigerant circuit
Note
The air conditioning system is operating correctly if the
air emerging from the vent on the dashboard is at a temperature
of 7oC or less.
Set the Climatronic to: “LO”.
Set the ai ...